Holder and stand for Galaxy S6 and wireless charging pad

thingiverse

This holder and stand is crafted specifically for the Galaxy S6 and a wireless charging pad, with the exact charging pad listed in the Bill of Materials. The phone slot is tailored to fit the GS6 with a tech21 case, but can be easily adjusted to accommodate any specific phone or case combination. A step file of the holder has been attached for reference, and other file types or a resized holder can be exported upon request. Note that the pictures shown depict an earlier iteration of the design, which has since been improved by removing excess material for better cable access. Print Settings: Printer Brand: MakerGear Printer Model: M2 Rafts: Not necessary Supports: Yes Resolution: 0.2 mm (layer height) Infill: 20% Notes: Printing without a raft on a heated, acetone-coated glass bed was used to achieve the desired results. A raft may be required if warping along the edges occurs during printing. A honeycomb infill pattern was employed, but other infill patterns should work equally well. Custom Section: BOM: * Integrated car charger with 150W power inverter: http://www.amazon.com/BESTEK-Inverter-Charger-Charging-Shared/dp/B003SGJIRO/ref=sr_1_1?ie=UTF8&qid=1456586715&sr=8-1&keywords=BESTEK+150W+Power+Inverter+Car+Charger+with+2+USB+Charging+Ports+%283.1A+Shared%29 * Charging pad: http://www.amazon.com/Wireless-Charging-Pad-CHOE-Qi-Enabled-Adaptive/dp/B016DAFUGY/ref=sr_1_2?ie=UTF8&qid=1456587012&sr=8-2&keywords=CHOE+Qi+Wireless+Charger+pad * USB to micro-usb cable rated for at least 2A: http://www.amazon.com/USB-Micro-USB-Cable-5-Pack/dp/B0157S9VY6/ref=sr_1_3?ie=UTF8&qid=1456587012&sr=8-3&keywords=usb+to+micro+usb+cable