Holden SS Emblem Keytag (Medium-Res)

thingiverse

Holden Commodore VE SS emblem keytag designed with precision. Dimensions: approximately 82mm in length, 13mm in width, and 3.5mm thick (3 1/4 inches by 1/2 inch by 1/8 inch). Print Settings: Printer: Duinotech TL4090 Rafts: No Supports: None required Resolution: Layer Height at 0.25mm with Path Width of 0.35mm and no additional shells Infill: 10% density achieved Design Notes: These print settings were used, but they should work well with most other configurations too. File resolution is a bit rough, so there's limited benefit in printing at maximum resolution. The file was created from a .JPG image using 3D Builder and 123D Design software.