"Hold this for me" statue

thingiverse

Thanks to Peter3dmaker for the original design. I remixed it into this "holder", which can hold something. **Important:** The upper body has a hollow section. After printing, fill it with heavy objects like old bolts, nuts, stones or similar items. The heavier they are, the better. Then seal the hole with gypsum, concrete or resin to prevent the holder from toppling over when you place an object in its hand. To print this design successfully, you may need some additional support. Try printing it at a light angle and using a raft. Up-scaling is acceptable, but down-scaling is not recommended, as it can result in walls that are too thin. I created this design just for fun and have not printed it yet. If you decide to make it, please share your results with the community. This design has been published on Thingiverse under #3967471.