HOe / HOn30 / HOm / HOn3.5 Queensland Railways (QR) 14' F Wagon
thingiverse
Queensland Railways (QR) F4 Wheel Open Wagon For: 1:87, HO Narrow Gauge What it is: A low-detail, four-wheel wagon that's not up to the quality of modern ready-to-run wagons. This is a kit! No buffers are supplied; use HO Cast white metal or Wuiske Models' WPD012 "Early Freight Buffers" (untested). Three versions are available: * HOe: using Dundas Models 8mm wheels/15mm axle and 1mm top hat bearings * HOe/HOm/HOn42: using Bemo 8.5mm wheels/18.5mm axle and 2mm top hat bearings * HOm/HOn42: using Wuiske Models QRB080 7.6mm wheel/20mm axle sets and 2mm top hat bearings (untested, as I don't have any 20mm axles) Additional parts needed: * Four 2mm "Top Hat" Bearings - 00 Gauge Romford Pin-Point Brass Bearings, shouldered type DW22 (I got my last lot from dundasmodels.co.uk) (1mm for HOe version) * A 2mm drill to gently clean out the axle holes (1mm drill for HOe version) * 0.5mm brass wire * Couplers, not set up for any type/brand * Fill a Gap Super Glue Notes: The short walls go on the inside. The final product will depend on the quality of the printer and how well you have your settings under control. Supplied as is, no support and no promises. I recommend using a 0.3mm nozzle for better detail and 0.1 or 0.08mm layering. ** FYI: Found a small mistake in the fitting of the side frames; please check that you have V1-5-3 or later. (Earlier versions need 0.5mm trimming of the length of side frames.) Please leave a comment if you build one!
With this file you will be able to print HOe / HOn30 / HOm / HOn3.5 Queensland Railways (QR) 14' F Wagon with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on HOe / HOn30 / HOm / HOn3.5 Queensland Railways (QR) 14' F Wagon .