Hobby King Rattler 1/8 Buggy lower Arm

thingiverse

Printer Settings Rafts: Yes Print Supports: Yes Layer Resolution: 0.2 mm Infill Density: 100% Notes: Assembly screws require special attention, specifically the shock and suspension shaft retainer screws which demand a precise drill bit, such as 5/64 inches. To ensure accurate assembly of suspension shafts, begin by drilling through it with an 1/8 inch drill bit; finish the job perfectly using the very same suspension shaft to complete the procedure once both ends have been fully penetrated. To guarantee an ideal hole size for smooth motion, operate the device at maximum speed until heated evenly throughout its length, then remove and let it cool completely. Lower ball joint screws should be drilled precisely with a 9/64 bit, afterwards threading is easily accomplished using an M4X0.7 tap which produces accurate threads before being fully screwed in