HO Slot Car Track Clips

thingiverse

This design provides clips that are used to hold parallel track sections together firmly, avoiding gaps between the track sections. These are useful for four lane track layouts, where two 2-lane track sections are laid in parallel. The SCAD design file can be modified as needed. Parameters in the design file allow clips to be generated of different widths, given that the sidewall of different track brands will typically vary from 1 to 2 millimeters. The STL file will print a set of four different clips, which assume that the sidewall for each section is 1mm: 1. Straight section clip 2. 6 inch radius clip 3. 9 inch radius clip 4. 12 inch radius clip These are attached by a thin strip that can be cut with a scissors after printing.