HM-LC-Sw2-FM

thingiverse

Attention! This is a DIY project! Use at your own risk, the designer assumes no liability! 230 V AC Project!!! Connect to 230 volts only by an expert! Failure to comply may result in severe personal and property damage. These files are completely free. Share them with your friends or modify them as you like. Commercial use is strictly prohibited! If you enjoyed this project, please share your creation, leave a Like, collect for the community, or post it on Facebook or Instagram! To show your appreciation for my hard work on this project, consider donating via PayPal. https://www.paypal.me/schmelzerboy Contact me via Facebook: https://www.facebook.com/jan.oerter?ref=bookmarks Commercial use is strictly forbidden! The Creative Commons license explicitly prohibits commercial use! PCB: https://github.com/ronnythomas/HM-LC-Sw2-FM Contact for ordering PCBs: https://www.facebook.com/ronny.thomas.83 Important!!!! 1. The sandwich board must not be higher than 31 mm, or the housing will not fit. 2. There are switch series (e.g., Gira) that do not require additional springs. Gira has springs built into the switch. Busch + Jäger requires additional springs to keep the rocker in the middle position! Therefore, there are two versions of the base body! Schmelzerboy proudly presents: HM-LC_SW-FM Underpanel Switch HM-LC-SW-FM Compatible with these switch series: Busch + Jäger, Gira, Kopp, Jung, Berker, Merten Bill of Materials: - Mirotaster 6/6/5mm - Two M2x6mm - Two M2x10mm - Two M2 discs - Four M2 nuts M2 nut and M2 cylinder screw, buy the best M2 M3 Set. https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.de%2Fulk%2Fitm%2F282511902775 - Installation adapter for Busch-Jäger switch https://www.elv.de/homematic-installationsadapter-fuer-busch-jaeger-schalter-fuer-smart-home-hausautomation.html - Spring set 246-piece https://www.amazon.de/dp/B00GN3BJT4/ref=cm_sw_r_cp_apa_i_kT00Cb8DXP6BG