HJV SpoolHolder & Rail

prusaprinters

<p>When I builded my printercabinet, I had a brainfart making of an spoolholder, what is attached on a rail and the rail is attached on the cabinets sidewall. Then the spoolholder could be moved from front to back ways if needed.</p> <p>Rail: 280x41x10mm</p> <p>Rail holes: 3x4,5mm</p> <p>SpoolHolder: 30x78,4/35x115mm</p> <p>Spool max. width: 90mm</p> <hr/> <p>31.1.2019</p> <p>SpoolHolder with roller</p> <p>Spool max. width: 84mm</p> <p>Bearings: 608 / d8mm / D22mm / B7mm x2</p> <p>In roller mode, I recommend to use sandpaper in bearing holes, because printing orientation might get those too tight. I myself putted main piece in hot water, then pressed bearings in place.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>CR-10S</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0,2mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>10-20%</p></div> <p><strong>Filament:</strong> Real PLA / PETG <br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Rail printed with 4 shells and 3 top/bottom. Holder 3 shells, 4 top/bottom.</p> In roller mode, I recommend to use sandpaper in bearing holes, because printing orientation might get those too tight. I myself putted main piece in hot water, then pressed bearings in place. </div></p></p></p> Category: 3D Printer Accessories