Hitch Pivot

grabcad

Step 1: draw a 2d sketch rough outline on the front plane with proper dimension and boss extrude but make sure you put extrude on midplaneStep 2: now go too the top plane and you'll make some cuts, first you'll make some triangle on the side that's away from the right plane too proper dimensions and cut for the other cut on this plane you'll sketch out a rectangle type outline ad cut thatStep 3: where you made those triangle cuts you'll draw on the tip of that face and create the little circle cutStep 4: were going back too the front plane from step 1 and chosing that face and using the tool offset entities were gonna make a cut before we make the cut with proper dimensions you have to extend the end of the entities because there's a cutout at the end so you just have to extend the lines and reconnect them and when you cut your gonna cut to the closest cut point no the furthestStep 5: within the same cut in step 4 were gonna use the same tool but you'll just have too make sure that you create a line that separate both cuts and with using the same too you should be able too repeat the process