Hiprecy LEO - PrusaSlicer Profiles

thingiverse

These are the profiles I use in PrusaSlicer for my LEO with good results, with six files included. Printer Profile 1: Hiprecy LEO - ABL This profile runs a bed leveling routine prior to printing and saves the results to the EEPROM for future use with Profile 2. Printer Profile 2: Hiprecy LEO This profile grabs the bed leveling data created with Profile 1 or the ABL GCode file provided, enabling bed leveling without actually performing the leveling routine. Filament Profile: Hiprecy LEO - PLA This profile sets the extrusion multiplier to 95% and leaves part cooling fans off for the first three layers. You can adjust temps as needed. Print Profile 1: Hiprecy LEO - .2mm This is the profile I use for final prints at .2mm with a speed of 60mm/s. Print Profile 2: Hiprecy LEO - .28mm This is the profile I use for final prints at .28mm and a speed of 60mm/s. ABL GCode File This file can be put on your SD card to run the bed leveling routine when needed. As with Profile 1, this file will save the results to the EEPROM for future use with Profile 2. Notes: I don't use Profile 1; instead, I prefer to use the ABL GCode file when it's needed and slice only with Profile 2. If you prefer running ABL before every print, then Profile 1 is best for you. Both profiles have entries in the start GCode for Linear Advance, Acceleration, and Jerk values, reflecting the settings in my custom firmware. Note that the Linear Advance value only makes a difference if it's enabled in the firmware; it's not enabled by default on the LEO. I suggest enabling it as I've found there is a noticeable improvement in print quality when used. Update 3-23-20: I have tweaked the profiles further and am getting better results. See included photos of some test prints.