Hinge pin

prusaprinters

<p>The 10mm bar I had was rather too snug for my liking so I modeled a replacement part with a diameter of 9.8mm to account for my printers inaccuracy. I also added a threaded 4mm hole on one end so it can be pulled out easily.</p> <p>Hope this is useful to others, total print time was about 4.5 hours with my printers settings.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Anet</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>A8</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.08</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>80%</p></div> <p><strong>Filament:</strong> Hatchbox PETG White</p> </p></p></p> Category: DIY