Himoto Barren bumpers and more (aka Basher Pbull) 1:18

thingiverse

Made some bumpers since the kids were killing these cars because they are so fast. Also made some body posts, canopy posts since those were worn off and some wheel adapters to fit 7mm wheels with normal holes and not one straight side like the barren wheel axle. Print bumper with a backplate and use M3 bolts or screws (20mm). You can choose to also use some M3 nuts at the back. The high front bumper also has a high support which you can use with 2 short bolts. For the low hole in the bumper, use the original screw from the car. I also use some ty-raps for extra support on the high bumper and that will also hold the double canopy holder. Bumpers can be printed on 0.3mm and infill 60% if you want. Printed mine infill 100%. You may also use some hot glue behind the bumper to make sure it really doesn't come off. The body posts are part of the upper deck and to replace them, you need a complete new upper deck. Now with my design, you don't. The canopy will be a little higher at the front but it will not come off. I recommend you print all parts with flex except for the 7mm wheel nuts (wheel adapters). I made some in different heights and you may have to increase or decrease size by 1-2% depending on material and shrinkage. These adapters fit the shaft with the flat side so you can use other wheels with 7mm nut holes. With these adapters, you can use these wheels A959 Wltoys: https://www.banggood.com/Wltoys-A959-RC-Car-Spare-Parts-Wheels-A95901-p-928687.html?rmmds=myorder&cur_warehouse=CN