Hills Hoist Handle

prusaprinters

<p>This handle is for a pre-1950 hills hoist that has a narrowing in the crank handle 25-29mm from the proximal end. The crank shaft for this handle is 14.5 mm diameter. I have narrowed the internal part of the handles to sit in the divot at approximately 27cm to sit in the 11mm diameter section of the shaft.</p> <p>the -16 uses a small screw to keep the handle from wandering off</p> <p>I will add a grub screw set-up in the near future</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>i3 MK3</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>.4</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>15 (can do 10) cubic</p></div> <p><strong>Filament:</strong> Prusament PETG black</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>This handle is for a pre-1950 hills hoist that has a narrowing in the crank handle 25-29mm from the proximal end. The crank shaft for this handle is 14.5 mm diameter. I have narrowed the internal part of the handles to sit in the divot at approximately 27cm to sit in the 11mm diameter section of the shaft. I used tinker cad.</p></div> </p></p></p> Category: 3D Printing