HighGreat Mark Tilting Camera Assembly

thingiverse

This is a set of 3D prints designed to enable the HighGreat Mark camera to be rotated. The drone requires modification in the following steps: 1. Remove the 4 plastic patches under the motor arm swivel points by levering them up with a sharp knife. 2. Unscrew the 4 central screws using a flathead screwdriver. 3. Remove the 2 screws hidden at the centre of the battery box using a Torx screwdriver. Lift off the top and proceed. 4. Undo the 2 cross-head screws at the back of the PCB and then, carefully slide it back an inch or so making sure that the micro-switch PCB underneath does not become too dislodged. 5. Two tiny crosshead screws are located right at the front of the drone buried about halfway down; undo both of these. 6. Remove the starboard ribbon connector (the right one with the drone facing forwards). 7. Finally, you should then be able to slide the camera lens out. 8. Remove the plastic cover from the lens and replace everything in its original position. 9. Once the camera lens is free, print this thing, glue the camera into the square recess of the camera housing (ideally using the back plate), fit the 2 camera housing supports to the camera housing, and then glue the whole assembly to the drone making sure that it sits over the small lip surrounding the original camera position.