Hictop 3DP-11 Y Axis Belt Tensioner

thingiverse

I built this to fit snugly onto the bed mount, but I'll admit it's not the simplest thing to tighten. You'll need to tilt the printer back to access it, which can be a bit of a challenge. I experimented with designs that would make it easier, but ultimately wasn't satisfied with my results. WARNING: If you trim your Y-axis belt to fit perfectly in the provided holder, you'll end up with a belt that's too short for this setup. I learned this the hard way after taking apart my printer - I had to purchase a new belt from a local 3D printing manufacturer. Print Settings: Printer: Hictop 3D-P11 Rafts: You can choose whatever you like, it doesn't matter. Supports: None needed. Notes: I printed mine with a layer height of .2 mm and an infill percentage of 25%.