"HexiBox" Tang Band W3-1876S modified sub enclosure ender3

thingiverse

I just took the design and crudely cut 2.5mm of width off each side which changed the overall width to 235mm This modification has made no changes to the internal design and should not affect any functionality, but enabled it to be printed on a stock ender3 pro with as delivered 220mm bed yes, your ender3 will happily print 235mm wide. you must remove the power supply and rest it on its side next to the printer. if you are going to use large clamps then you must also remove or move the display over a hole too. I used Prusaslicer, changed bed size to be 240mm by 220mm, set origin offset to I believe -3x -3y. the top printed correctly and the bottom didnt for me so be sure to print some tests and measure your print as it goes to ensure correct widths. you will also want to whip up some 235mm test strips to print out and measure to ensure your steps/mm is completely accurate. other thoughts: it warps like crazy, I have no idea how this is supposed to be printed. my bottom warped so hard that it caused a visible messsed up line the height where it prints the inner horizontal wall. I added feets for the top which is now the bottom and I paused the print at I believe z8 and added incredibly strong clamps. This caused it to actually crack and break towards the upper 40zs. in the end it sprung into a warped shape as soon as the clamps come off anyway. if you want an art piece then you are probably going to have to build a heated enclosure.