Hexe Sound

prusaprinters

<p>I designed these hexagon shaped reticulated foam holders to install in my room where I mostly do Video Conferencing, The holders are 4-¼' &nbsp;per side with 1-½" deep.</p><p>Overall measurements:</p><p>Widt 8-½" &nbsp;</p><p>Height 7-¼"</p><p>Depth 1-½"</p><p>&nbsp;</p><p>There are two mounting holes on the back which allow you to configure 2 ways and they also have perforated base to reduce the amount of material used for printing as well as to catch rear reflections from the wall.&nbsp;</p><p>Included in the files are 2 types of spacers to allow for a gap between the wall and the panel. You can also mount flush to the wall but recommended to leave an air gap to improve results.&nbsp;</p><p>Spacers are ½" and 5/8"&nbsp;</p><p>Installation of these are up to users discretion and screws + anchors are recommended but optional. Double sided tape might also work.&nbsp;</p><p>Recommended settings and material are up to you but I used SUPERDRAFT settings and my infill was set to 15%. The lower the infill the less material, the less the weigh on these.&nbsp;</p><p>&nbsp;</p><p>I hope this is useful to you and feel free to leave some feedback</p><p>&nbsp;</p><p>&nbsp;</p><p>&nbsp;</p>