HexagOhm - DIY DNA Hexagon Box Mod

thingiverse

A Compact DNA Board Box Mod. As Seen on Reddit. Upload Your Creation When Printed. Designed Using FreeCAD - A Long and Frustrating Task. Print Settings Printer Manufacturer: RepRap Printer Model: Mendel Max 1.5 Rafts Needed: Irrelevant Support Material Required: None Layer Resolution: 0.1mm Infill Percentage: 15 to 20% Notes on Print Quality: The First Layer Should be Set to 0.2mm Thickness Instructions To Facilitate Smooth Filament Swapping, a M600 Command has been Added After the Initial Layer. The Hexagonal Features Have a Height of 0.2mm. This Code Will Switch to a New Filament Without Interfering with Print Quality. However, Its Effectiveness Remains Uncertain for Printers without an On-Board Display. When Executing this Process, Take Care Not to Move the Extruder as it Will Be Powerless and Exposed During Filament Swapping. Automatic Retraction of the Filament is Assured. Also Consider that if a Hexagons height was reduced, or no more than 0.1mm the filament change might work flawlessly with any DNA Board with out need to change M600 code at all in some specific printers with 0,9 and lower firmware