Hex key guide for rebound adjustment knob on Fox Step Cast 32 forks

prusaprinters

<p>Guides a long 2mm hex key to make it easier to loosen or tighten the small screw that holds the rebound adjuster knob in place.</p><p>The Fox Step Cast 32 is a great fork. Rebuilding one it isn't much more difficult than with the standard Fox forks, except that the hex nuts holding the air spring and damper shafts in the fork are recessed pretty far up into the fork legs. Accessing the nuts isn't hard if you have an extension for the socket, but the rebound damper is much trickier, as it is held on using a small screw with a 2mm hex head. Not only is the rebound knob deeper than most 2mm hex wrenches, it's also sunk pretty deep in the fork, so it's <i>really</i> tricky to reach. This thing helps out with that. Just make sure you have a hex wrench that's long enough and doesn't have any fancy coatings or shapes.</p><p>To use - print this thing out and it'll insert into the end of the rebound adjuster knob, and then as long as you have a long enough 2mm hex, it'll pass through the middle and be guided to the right spot. The thing also serves to hold the rebound adjuster knob so adjustment doesn't change during the rebuild. (although it's a really good idea to know your setting before you open the fork)</p><p>Prints fine with no supports needed.</p>