hex case

thingiverse

Created with Customizer! https://www.thingiverse.com/apps/customizer/run?thing_id=58001 Using the following settings: Include hooks: off Height of model part 4: 9.5 units Width of model part 4: 58.55 units Rotation of the image on the 3D printer bed: 30 degrees Thickness of model part 5: 1.0 units Width of model part 5: 6.1 units Type of phone case desired: case type 2 Radius of pattern at edge of model part 4: 9 units Model parts are allowed to overlap during printing: no overlap allowed Thickness of wall for model part 4: .6 units Pattern on model is a 6-point star shape Width of model part 4, adjacent to 5th part: 6.17 units The images that were uploaded are at 100% scale size Width of model part 5: 58.6 units No image input was given for custom design Tolerance level for calculating the perimeter length on model part 4 is .5 units Color scheme primary color desired is red, for display purposes only Index i setting on thing designer app: index_i = 1 Index j setting on thing designer app: index_j = 0 Overall length of the main model component part 4: 115.25 units Taper angle to curve outward, to smooth out corners on model part 4 case: case taper angle = 3 degrees What iPhone generation desired case will fit in with dimensions? iphone version setting is at 2 Case thickness, in mm. Units can vary: .1, or just point 1 of a unit of millimeters, or .001 inches etc. etc.. and all measurements must be given using metric units : case_thickness = 18 units. Model part five’s height has a minimum size of plus/minus: height tolerance of +/-0.2 units Desired overall length model part 5, as requested in units.: 123.8 units Distance of rounded corners at point r on side of model part five in mm. Must have an outer rounding, so is given as “corner R” - and so that should be: a + /minus height deviation tolerance of .2 Image will not need to undergo a rotation transformation: no pattern_rotation = 0 Desired location from top down, at which bottom edges meet model part four and/or any parts in front of model three.: vertical movement on the bed or platform (z-movements off Z): -move downward to point where you wish bottom edge “land” to come together: “offy= “ and move left:“ “offx=“ : zero value - no offset here. Horizontal location setting: horizontal offset movement is “ofY” from left or right. Setting has a: off value for no/ zero movement from x- position All dimensions set using this configuration match model designer's specifications in this Thing Description: as requested Tolerance of +/-0.5 on the outer width of model five - measured at part surface - (not to be confused with edge roundoff “R ” ): desired tolerance for part perimeters is 5% or better . Pattern’s maximum size/width should stay consistent across printing at + minus percent deviations – to not be more than 10 percentage point difference. It must maintain 6-star, six points pattern - if it's star shape- to keep consistency between edges.: setting the desired minimum allowed maximum width to 5 units: pattern_thickness=pattern_width max = pattern_shape thickness: (also “minimum allowed ” ):