Hex Bit Bracelet with driver

thingiverse

This is a remix of BiscuitsOnTheFloor's Bit Link Bracelet. I decided it needed a link that could be used as a driver handle, so you weren't just storing the hex bits, but could actually use them. So I over-sized one of the existing links for this use. I also added two additional link types, a small one that doesn't take a hex bit and one with offset heights (see picture). These extra links helped me to size the bracelet to better fit my wrist. As with BiscuitsOnTheFloor's Bit Link Bracelet, I also used the same buckle from ChrisMUC. I had some problems printing it with the very small gaps between the plastic, so modified these gaps to be a bit wider which improved the print for me. Printer Settings: Printer: Wanhao i3 Rafts: No Supports: No Resolution: 0.1 Infill: 50% Post-Printing Some sanding/filling of the hex holes was required to get the bits to fit (however be careful not to overdo it as then they might fall out). I also drilled a hole in the back of the driver handle link. This allows you to use one of the other hex bits to eject the current hex bit once you are done using it in the handle.