Hevo XY for COMPACT 10mm misumi bearing side printing

thingiverse

I'm working on remixing the side printing for hypercube evolution, scaling it up to x8 y10 and x10 y 10 versions. These prints are not test runs, but rather designed specifically for Misumi compact 10mm bearings, which differ from the standard LMU bearings. The key difference lies in their width - compact bearings measure 17mm wide, whereas standard ones are 19mm. This distinction requires a custom approach to printing. One notable feature of these remixes is the inclusion of an offset Y flag. You can find the original design for this flag on Thingiverse at https://www.thingiverse.com/download:6227900. The original hypercube evolution print employs standard 10mm Y rod bearings and 8mm X rods. For reference, you can view the original design on Thingiverse at https://www.thingiverse.com/thing:3501612. To combat petg shrinkage, I've adjusted the bearing half moon from its original width of 17.2 to 17.3, then further reduced it to 17.1. However, I'm experiencing difficulties with printing these remixes due to the petg material curling and causing layer shifts.