Hero Me V5 with Micro Swiss extruder/he Gantry Mod

thingiverse

This is a modified gantry (4B) from the hero me v5 collection. It was modified to fit with a Micro-Swiss dual gear direct extruder with hotend kit. I used some red silicon ptv to help seal it to the machined base. I didn't think I needed to drill and tap an additional hole. The h5 fans seem to be holding fine. Once I changed the gantry to allow the hotend to sit flat on the machined base, all of the other parts fit normally. I went with dual 5015 fans and ducts, and have a bltouch sensor. all fit fine once you figure the right parts......