Hero Me Gen4 for the last CR-10S PRO release (V1, not V2)

thingiverse

I encountered a problem because Creality has reduced the size of the plate on the left with the last release of the CR-10S PRO. I'm not talking about the V2 from TM3D with the BLTouch already installed. Check out this photo here: https://www.thingiverse.com/make:753190 And my own photo is available here: https://cdn.thingiverse.com/assets/4f/4e/b1/a2/1b/IMG_20200512_144649_-_CR10s_pro_original_vs_upgraded.jpg You can see more details here: https://www.thingiverse.com/make:803681 I had to cut the rounding on the left of the support because the metal tab of the X limit switch comes into contact with the plate, not the tab of the support. Now I have a problem: I received my 5015 fans and I want to install one on the left. So I need to use the support for BLTouch 1 or 2 (to put it more to the left), but if I do that, the BLTouch will hit the left X engine. I resolved this issue by: Hero_Me_Gen4_CR-10S_Pro_Upgraded_Base.stl: I either enlarged the tab of the support to the left so it's the same size as the turntable on an old CR-10S Pro model and added a deep recess so that it's this part that comes into contact with the metal sensor tab. I also enlarged the hotend screw holes for easier installation. BLTouch_Bracket_One_CR10s_Pro_Upgraded.stl: I extended the BLTouch support to put it further forward to avoid touching the left engine of the X. It should be angled to pass between the left duct fan and the engine. This part is used with the 2 right fan ducts. griffe bltouch 60.stl: Another BLTouch bracket, this one is for use with the dual fan duct that has a 5015 fan installed at a 60° angle.