Hero me gen 7 - SUPERVOLCANO - fan duct system - 5015 blower fan

thingiverse

plz donate i'm poor <3 and aspiring x) or conspiring 0.0 This is designed to fit the Hero Me Gen 7 Base To get access you have to subscribe to MediaMan3d on patreon (it is no longer open source) (costs $3 for lowest level subscription) then you can unzip the file and pick the parts. (If you have a printer that is not on the list, all you have to do is 3d model a gantry mounting adapter to attach to the base[you can do it i believe in you]) I can imagine this would be difficult to print with an FDM printer I can also imagine with a little bit of heat you can make it fit I printed this using my resin printer and it came out perfectly centered with the nozzle in the orientation shown In the photo It's nice because it blows nice and hard, but also it's positioned fairly far from the hotend so it should withhold. I printed this with Siraya Tech blu resin. This printer is dedicated to PLA spiral vase mode so the blower will be on throughout the print and I shouldn't have to worry about the heat over time. keep in mind that the supervolcano prints like absolute garbage without a good part cooling system, so make sure you have your pieces ready, make sure they fit. you will need a 3m heat press soldering iron tip 3m heat set inserts (4mm long) an m3 hardware set including short pieces and hex nuts that is for the Hero me Gen 7 and this piece alike (requires heat set inserts) TY good luck and have fun guys&gals!