Hero Me Gen 5 Micro Swiss Direct Drive Gantry Adapter/Base

thingiverse

Human: 6/26/20 - 7:15pm EST: I uploaded a modified LED mount for my NEOPixels LED bar. The bar fits snugly, with a cutout on one side for the input wiring. Led bar: https://www.amazon.com/gp/product/B07KD6ZB88 6/21/20 - 12:41pm EST: I measured the offset for my BLTouch compact wing and standard mount, finding it to be X -57, Y -18. Be aware that offsets will vary with different machines, so you'll need to measure yours specifically. 6/17/20 - 5:58pm EST: ABL Mounts are now complete, awaiting testing. They should fit perfectly. 6/17/20 - 4:45PM EST: My current version .5a is workable, accommodating the hot end and fan wings. However, it requires a slight modification to the ABL sensor mounts to create space for the wings. The upper right screw now takes an M3 nut from the clip side (opposite to the original mount), and you'll need to use the lower 2 holes for the left cooking wing due to partial obstruction by the ABL mounts. I recommend installing captive nuts on the inside of the wings before mounting, as there won't be enough room afterwards. I also used CA glue to secure them in place (similarly for the front nuts that go into the slots in the bottom). 6/17/20 - 12:41PM EST: After several revisions and prints, I think I've created something workable. As soon as my current print is complete, I'll post back and decide whether to modify the wing bases or fan mounts. 6/17/20 - 12:57AM EST: I have the modified base/gantry hack but haven't printed it yet for a test fit. It will require some modification to the ABL mounts to clear the cut necessary for mounting the fans, which I'll address once I have a physical part in hand. 6/16/20: I need to redo this piece as I didn't consider the extruder's alignment with the heatsink path (it sits too far forward). If I cut down the base enough to mount the heatsink correctly, the main base will be ahead of it. This won't work as is, affecting parts fans and other components. 6/15/20: The v2 clip file has a hole for the heatsink screw, just in case yours are longer and protrude from the back.