Hemera fan duct with integrated ABL mount for Artillery Genius/Sidewinder

thingiverse

Update 2 - 06/12/2020 - Added v3, superseding v2 with only minor aesthetic changes and additional clearance for wiring the probe. Update 1 - 06/12/2020 - Added v2 with central duct outlet included to improve cooling while maintaining a view of the nozzle. This is a remix of a part cooling fan (5015) duct for the Hemera, integrated with a mount to use the stock z endstop sensor as an ABL probe on the Artillery Genius or Sidewinder X1. The main purpose of the remix was to incorporate the sensor mount, allowing auto bed leveling thanks to Ciprian's guides at 3dprintbeginner.com: https://3dprintbeginner.com/artillery-genius-auto-bed-leveling-stock-sensor/ https://3dprintbeginner.com/sidewinder-x1-auto-bed-leveling-stock-sensor/ The duct has been revised for a better view of the nozzle by removing the central outlet. Side outlets have slightly increased to help compensate, reducing overall cooling output (still fine). I may reintegrate the central output. Mounting the sensor flush with the bottom of the bracket and fan duct puts it in approximately the correct position relative to the nozzle. There's also plenty of adjustment available for the probe up or down while maintaining correct perpendicular alignment to the bed. M3 hardware, including washers (12mm on the sensor), is required. Nozzle to probe offsets are: X 40, Y -47. It can be printed without supports in the installed orientation.