Hemera carriage for Hypercube Evolution (BLtouch + part cooling fan)

thingiverse

I modified dbrandao's extruder carriage to fit my specific requirements. Additionally, I designed and built a custom fan holder that utilizes a 40x40mm radial fan and accommodates a BLtouch sensor. The following changes were made to the original source file: - A square hole for the endstop connector was enlarged as my endstop did not fit properly. - Counterbored holes for screws and nuts were sunken by 1.5mm to allow the use of the mounting screws that came with my Hemera. - The dowel pin and mounting screw hole received a chamfer to facilitate easy installation on the Hypercube's carriage. - An option was added to incorporate strain relief tie-wraps. The probe offset is as follows: X=-3, Y=-44, (Z=0.15, however, please verify this value yourself). Please note that due to the Hemera's width being greater than the X-carriage, the full 300 in X can no longer be reached. I do not find this a concern but it is worth mentioning. Inventor part files are included for reference.