Hemera 5015 Part Fan with BLTouch

thingiverse

This mount has been remixed from a source that remains unknown. If someone created this original design, I'd like to extend my apologies for not being able to give proper credit. The bracket attaches to the left side of the Hemera with top/bottom bolts. The 5015 fan simply clicks in place and is secured with an M3 x 20mm screw. To align it properly, I heated up a M3 nut and inserted it into the rear of the hole, allowing for about 5mm of vertical adjustment. I'm not certain if I used M3 x 8mm screws to attach it to the Hemera, but be sure to verify this to avoid damaging any fixing points. I printed this mount at 100% scale with support only under the BLTouch part, so you may need to manually add that as I did. To achieve the best results, print it in the position shown in the picture, with the fan funnel on the base. You might also need to rotate the Heat Block by 90 degrees. Unfortunately, I don't have any offset data available since I haven't had time to set mine up yet, but this mount does run and performs well. To ensure a smooth print job, use PETG or ABS material, as the Hot End is quite close and may melt otherwise.