Hellraiser Cube Stand

thingiverse

Printed this incredible Hellraiser puzzle box and I couldn't find a stand for it that I liked so I had to make my own very appropriate one. Found some chains and hooks and mixed them together to form this very Hellraiser themed stand. I imagine you can use it very any cube really. Prints with no supports. Discard the three cones that support the three half-rings without supports. Print 3 hooks and super glue them onto the slotted rings. Don't crush it down on the hooks or you might break them, so be a little gentle. Mine has lasted every since I printed it 5 years ago. Wish I had shared this sooner. FWIW I cannot find the model I used for my Hellraiser box, but I know it was based on these [amazing designs](https://www.thingiverse.com/thing:1150234). UPDATE: Added version 1 of this model. I'm pretty sure this is actually the model pictured. Sorry for the confusion. The earlier upload was the improved version and it's scaled bigger so might not be the same look. UPDATE 2: Added a new version 6b. This is an improvement on the version 1 design with better assembly. I'm having trouble with my printer at the moment, so I haven't tested it, but I'm pretty sure this will work. Will update once I've printed and tested it. UPDATE 3: Got a successful 6b print, new photos added. Updated 6b to separate the hooks from the ring. You'll need 3 hooks obviously. You can likely print the hooks with no supports and no brim, but you might need a brim. For the ring I had to go to an 8mm brim to keep it from lifting. No supports required, but you might have to cut the little cones off. The hooks might need minimal sanding to fit, and then super glue them in place.