hell and heaven angels!

thingiverse

I printed these lovely angels with precise measurements of 100mm x 150mm x 4mm. With a building time of approximately one minute and thirteen seconds, this was quite an experience! The most challenging part, however, lies in carefully removing the angel from the print bed after completion. To achieve a smooth process, it's essential to apply a significant amount of Elmers Glue Stick beforehand, then use a scraper to peel off the model slowly and gently, starting from the top right corner. The following settings were used on the XYZ Da Vinci printer: ABS as the primary material Layer thickness set to 0.20mm 30% density for added stability Shell layers are normal in orientation A standard speed was chosen for optimal quality No raft or support was generated during printing The design was rotated to face north, with the head oriented accordingly