Height adjustable feet for IKEA LACK table

thingiverse

For my 3D printer, I design a housing using IKEA LACK tables that stand very straight on the floor when properly assembled with legs. Unfortunately, the exact spot on the floor where I wanted to place the tables was uneven, so I create adjustable feet in two versions. **Foot-Base_V1.0** ---------------------- This is the height-adjustable foot. A quadratic variant exists on Thingiverse (thing:2187583), but it doesn't make sense to me visually. I choose an M4 screw for my design because I had it in stock, and it provides more than sufficient stability, although it looks a little strange. _Additional parts:_ 4 pcs. hexagon screws M4x30 (or longer) 4 pcs. Nuts M4 _Printer Settings:_ Material: PLA Resolution: 0.2mm Wall thickness: 1.2mm Infill: 50% Support: yes Adhesion: Skirt **Table-Support_Var1_V1.0** ---------------------------------- The first variant of the table support encloses the leg from all sides, requiring a hole to be drilled in the middle for the M4 screw of the base part. If you want to attach the parts to the leg, predrill screw holes. _Additional parts:_ 4 pcs. Nuts M4 8 pcs. countersunk wood screws (optional) _Printer Settings:_ Material: PLA Resolution: 0.2mm Wall thickness: 1.2mm Infill: 50% Support: no Adhesion: Skirt **Table-Support_Var2_V1.0** ---------------------------------- The second variant of the table top requires more effort but is almost invisible and more appealing in my opinion. You must hollow out the table leg first, which can be relatively simple as chipboards are only 1cm - 1.5cm thick and crumbly. However, if you're unlucky, a 3.5cm plate of more stable material may be glued in. I think the effort is worth it, and the result speaks for itself. _Additional parts:_ 4 pcs. Nuts M4 _Printer Settings:_ Material: PLA Resolution: 0.2mm Wall thickness: 1.2mm Infill: 50% Support: no Adhesion: Skirt