HedgeHog House

thingiverse

I designed a miniature house slightly oversized, so I scaled it down to 80% of its original size. The printed dimensions are 12 inches by 6 inches, but the actual house is only 6 inches x 6 inches in size. This design features a small porch and built-in food and water bowls. My print was watertight, which I'm pleased about. I didn't use any additional supports except for those included in the door archway, which should be removed after printing. The house was printed with a 10% infill setting, resulting in a sturdy structure. I estimate it took around 12 hours to print the main house portion. During the print process, approximately 99,546 mm of filament was used at a layer count of 347. Printed on April 30th, 2018. Once my hedgehogs' new cage is complete, I'll upload photos for everyone to see. If you decide to print this design, good luck! Please share your pictures with the community. Photos were added on November 26th, 2018. Upon reviewing them, I noticed some issues with cooling problems on the roof.