HecTech FPV H Quad v1

thingiverse

Human: I was inspired by quadcopter designs from the IOFPV hex & can utilize its canopy as well. https://www.youtube.com/watch?v=WhVgwvBBYSE Instructions: 1. Print all parts at 100% infill and lay them flat, just like you would print anything. 2. Note: I'm new to SolidWorks, so I didn't think about the plane I was drawing on. You'll need: - 16x M3 6mm screws for motor mounts - 16x M3 25mm screws for clamps - 4x M3 screws for FC - 24x M3 nylock nuts - Zipties - a lot of them! - 2x 12mm carbon tubes cut to 300mm Tip: You may need to reposition the holes on the frame to make the 12mm booms slide in smoothly. I used scissors and carefully twisted the edges to fit properly. To fix this, drill a 6mm hole above the 12mm holes for the ESC wires to pass through.