Heater Valve Manifold Saab 900 Classic '78-'93

thingiverse

A classic cars aficionado asked me to recreate the broken heater manifold of one of his Saab 900. The purpose of this part is to conduct hot water, with temperatures that will surely reach 80º C, so it must be printed using a material resistant to high temperature (like PETG) and, of course, with a 100% infill. Dimensions look right, since my friend installed it without problems in his car, but I am not sure that it will withstand prolonged use with the temperatures that the heating circuit reaches, so if you decide to use it, it will be under your own responsibility. Good Luck. Changes: - In version 19 the diameter of one of the alignment pin holes was changed (I realized they are of different sizes to ensure a proper alignment of the part).