Heated Bed Adjustment Screw

thingiverse

Level Adjustments Simplified: Butterfly Nuts Under CTC 3D Printers' Bed Instructions To Ensure Easier Leveling: Replace the old butterfly nuts on your CTC 3D Printer's bed with the replacement ones, as this greatly improves leveling results. You'll need a total of four replacement butterfly nuts. I recommend trying the following: For Improved Results: Try printing with ABS filament and rotate the thumb wheel downwards. You'll see an instant improvement. Making Supports Easier to Remove: Use these settings for best results when working with supports: Align your support lines to run directly across the face of the nut opening, not into it. Opt for a support model spacing of 1 millimeter to ensure a smooth print process. Keep the support density at 0.25 for better quality prints. Ensure proper separation from the model by using a margin of 0.5 millimeters. Prepare the Replacement: Clean out the old butterfly nut openings with a utility knife and use a drill bit to remove any remaining debris in the center hole. Secure The New Nuts: Place one spare butterfly nut in the newly cleaned slot before installing your new thumb screws evenly across the bed. Installation Is Complete: Carefully lower down the bed, allowing each thumb screw to take even pressure to avoid stressing the heater assembly. Replace the thumbscrews for a stable printing experience