Headrest phone holder for Skoda Fabia 2 and Xiaomi Redmi Note 5

thingiverse

A phone holder designed specifically for small babies on child seats allows them to watch fairytales on their mobile device. This model is engineered to be mounted on Skoda Fabia 2 headrest rods with a pitch of 150mm and a diameter of 15mm. It's also suitable for Xiaomi Redmi Note 5, which has an inner space of 163x15mm. The holder is fully compatible with phone cases that have a stand ring at the back (see photos). The side holes in the holder allow for charging the phone while still allowing sound to pass through. It doesn't matter if the phone lies on its left or right side. If you have the same phone model but without a thick back cover, you can print one of two aids from this design. One is 60mm long and 5mm thick, and it's meant to be glued onto the backside (avoiding the area where the camera is). This will hold the phone on the front side of the case, facing the baby. The other aid looks like a hook and can be attached from the top side to the walls or used as a spacer. You can also attach it from the sides if you have a smaller phone, or from the backside if needed. Its walls are 4mm thick, but this is just an idea - you may want to design something better with different sizes. Important note: Use a fire torch like this one (https://www.aliexpress.com/item/New-BBQ-Torch-Turbo-Cigar-Lighter-Spray-Gun-Jet-Butane-Lighter-For-Kitchen-Cigarette-1300-C/32942642242.html) to remove sharp edges from the printed holder. This will make it safer and smoother for use in a car. Less important note 2: It's recommended to print this design with PET-G or another high temperature-resistant material. PLA is not suitable, as it may cause the holder to melt and flow from the car if exposed to heat.