Headphone Holder

thingiverse

V4: A countersink hole was added for mounting with drywall screws.\nV3: Version 3 was created based on a comment from MakerMucilli, which suggested adding a second screw hole below the support to prevent it from swaying.\nV2: Without supports and with an end detail that looks more refined, version two would be preferred over version one. In the future, I'll print v2 instead of v1 when needed.\nThis was made to hold a pair of Bose QC 15 headphones. I drew inspiration from the headphone holder by polxuriach, but designed this from scratch for the Bose QC 15. More fillets were used so that the design would suit my tastes. The open triangle in the lower gusset was also removed because it didn't look right to me. While a screw hole was added for permanent mounting, double-sided tape has been sufficient.\nPrint Settings\nPrinter: Monoprice IIIP\nRafts: No\nSupports: Yes\nResolution: 0.15mm\nInfill: 20%\nNotes: Version one required supports. Version two would not require supports. Printing version two is recommended.