Headphone Holder

thingiverse

I was really impressed with the headphone holder by Stevetecx because it's tiny, straightforward, and looks fantastic. My only issue was that it was structurally underpowered than necessary. I downsized the overall length so it's now proportioned to hold headphones with a maximum headband of 4cm. I also thickened out the bottom, maintaining a taper, to help shift weight from the tip of the holder to the base. I also adjusted the orientation of the model so it prints the strongest possible framework. Stevetecx recommends using a 3,5x16 Screw. I just discovered a screw that I had left over from another project that turned out to be a bit bigger. It caused a minor crack, but the holder is still strong enough now that I don't have to worry if my cat steps on it.