Headband Europa V3 (For A4 format)

prusaprinters

This version is for A4 size (Portrait or Landscape). Optimized for stacking, with flat top and total, constant height of 12.9 mm. Therefore it could be utilized only with narrow strap (8 mm), or if the strap is wider, it needs to be soft as to be forced through the ears on both ends. The stacked configurations are of 2, 4, 6, 8, 10 and 15 units. The gap between the units is 0.3mm, using 0.3 mm layer. All the 3MF files (Single and Stacked) have been set for: Infill- 30% Layer 0.3mm No support Nozzle Ø0.4 mm Detect Thin Walls: ON Detect Bridging Perimeters: ON Bridge Flow Ratio: 1,05 Perimeters: 3 Also adding the simplified lower bracket from V2 and the DXF for the shield. If you use this new simplified lower bracket, you do not need the punch the lower 3 holes in the shield (as the simplified bracket does not have pins and holes). If you prefer to use the original bracket with the pins and holes, then you need the lower 3 holes on the shield. If you are running with bigger nozzle or taller layer/gap, we are doing a lot of custom setups in the "Special Versions" thread here: https://www.prusaprinters.org/prints/27985-special-versions-for-v3-a4-and-240-x-240-formats Drop me a line and we can make it happen. The 3D printed headband information presented here is intended to assist the general public during the current global pandemic related to COVID-19 and the related nationwide shortage of personal protective equipment. Please be aware that this headband design is not intended to replace standard protective equipment when that equipment is available. The use of these 3D printed headbands has not been fully tested and has not been approved by federal or state authorities. The individuals associated with developing and producing this headband design assume no liability and make no representations, warranties, or guarantees regarding the safety, efficacy, or appropriate use of these headbands in any particular situation. Each facility should test each batch of headbands prior to relying on them for protection. Use of this information for any purpose is at the maker’s and user’s own risk.