Head cable middle guide

thingiverse

I crafted this manual to suspend a wire outside the action zone of the sliding rails on my **EZT T1 Delta 3D printer**, allowing the head cable to move freely around its center point while preventing it from getting trapped under the rails.\r\n\r\nTo enable movement, two objects need to be printed to hold a wire between them. Another wire keeps the head cable centered over the last one.\r\n\r\nI only had M4x12 rods available, so I modified my [previous design](https://www.thingiverse.com/thing:2997284) to mount this support insert rod and nut for a single lap, then inserted it into an aluminum profile at an angle using a screwdriver, turning it forward and backward until the nut fit snugly. When the nut was seated, I tightened it by pulling the support back, creating friction between the nut and profile that kept everything in place as I continued to screw it down.