HE3D EI3 Dual wide vent mount (fit V6 blocks)

thingiverse

I recently acquired a set of V6-style heat blocks (equipped with the cartridge thermistor) for my HE3D EI3 Dual printer, but unfortunately, the fan ducts no longer fit properly. To overcome this issue, I created a modified bracket that retains the original design's essence while accommodating the thermistor cartridge wiring by shifting the holes outward 5mm in each direction. To fabricate the heat vents, you should print the redesigned bracket and then use the remixed part to create the original ducts. A critical note: please refrain from using PLA for this project! During my initial attempt, I made the mistake of using PLA, which resulted in the bracket deforming when it became warm. A FreeCAD file is included for your convenience, allowing you easy access to modifications as needed.