HDZero VRX x-air and x2-air mount

thingiverse

To get a full left/right set, mirror each part in your slicer of choice and print again Print mounts face down. The plates for the hinged mount and the mount with indented front need to be printed with supports around the hole for the u.fl pass through. The hinges use a piece of 1.75 mm filament for the pin. I found squishing down the tip with a pair of pliers before inserting made it easier. I recommend assembling the hinge before gluing on antennas or clipping to the goggles, just in case you accidentally break a hinge. A kit for the x-air antennas with u.fl pigtails is available from TrueRC. The x2-air antennas with SMA antennas need to be custom ordered. Just write an email requesting to True RC with the request and include the pictures attached to this thing as an example. At the time I ordered, the cost for the pair of the x2-air antennas was the same as for the DJI kit. I also included clip in mounts for the x-air without the hinge, for those that don't want to use the x2-air antennas.