HDD wall mount / bracket / holder (WD)

thingiverse

Hard drive dimensions: Length - 180 Width - 116.7 Thickness - 36.8 HDD wall mount: Wall thickness is 4.8 mm, with a nozzle diameter of 0.4 mm and 12 layers. Each side of the holder features a 0.35 mm gap. When modeling, I planned to print the model in a vertical position, so I beveled edges under 45% to ensure smooth printing. The maximum angle for overhanging sides of decorative triangles is 50 degrees, making it suitable for both PLA and ABS plastic. There are overhanging parts with large angles, but they print well from PLA at 40 mm/s and a layer height of 0.28 mm. Printing from ABS may require some airflow. After pressing PLA plastic, I noticed the following shortcomings: Some angles were bent, despite using an ultra base coating. A brim might be necessary for better results. The large layer height caused sagging in the corner of the triangle, requiring a bridge print. This resulted in a slight S-shaped curve, but it's not critical. The rest of the model turned out great. If you like my work, consider supporting me by sending some coins for tea: WMZ: Z315805724463 PayPal: Dikovinniy@yandex.ru https://www.patreon.com/MrDialmax https://www.donationalerts.com/r/mrdialmax