HD Tool Organizer - Magnetic Base - Modular - Screwdriver, Wrench, Ratchet and Extension

thingiverse

This is a similar design as the other tool chest organizer that I posted earlier but this version used a longer magnet. So if you need more holding power, this might be your best route. The tool organizer uses a 30x10x5mm Neodymium Magnets and it slides in the base of each of the mounts. You might need to adjust your slicer to make sure the plug fit properly, because it should be press fitted and does not need any glue. Here is a link to the magnets I bought:https://www.amazon.com/Neodymium-30x10x5mm-Rectangular-Magnetic-Powerful/dp/B0B6P4PZ6RNoticed that some files is named "Short" than means they are shorted the others. The over all height is 5mm shorter. Regardless of the height, they will still link to each other. BUT these will NOT link up to the tool organizer that uses the smaller magnets because these are 10mm longer.No Supports was used to print anything here.Here is a link to my other tool organizer that uses a smaller magnet:https://www.thingiverse.com/thing:6454292