HC-05 / HC-06 Programming Holder

thingiverse

Every time I wanted to flash firmware on an HC-05/HC-06, I ended up soldering temporary wires to SPI pads and once finished programming, removing them. Thankfully now I don't have to! This holder gives access to the 4 SPI pins along the bottom plus VCC and GND on the left-hand side. Wires used I used standard single-core breadboard/jumper wire, which I believe is 22AWG. Stranded wire isn't worth trying. Holding the chip in place I've successfully used both elastic bands and Blu Tack. Print Settings Printer: Anet A6 Resolution: 0.2 Infill: 100% Notes: Print Time: 00h 14m Filament Used: 2g Post-printing After the print, I used a pin to clear any debris and smooth out the holes.