Hazbin Hotel Clock Tower

thingiverse

UPDATE - August 02, 2022. Added a more accurate roof section with upper and lower spikes, A new optional central tower section with an embossed image of the demon seen in the show, as well as I updated a few of the parts to have better internal ceiling angles to reduce or eliminate the need for supports. (The tower sections, and the Dial sections) I have also added an image with some posters I threw together to match or fit the ones seen in the show that you can scale and print to apply to the tower as seen in the show if you so desire. This is the Clock Tower seen at the beginning of the Pilot Episode for Hazbin Hotel by Vivziepop. It counts down the time between the annual purges in Hell. I've always had a soft spot for clock towers, and am also a tremendous fan of Vivienne's work, so I decided this would be a good first project to tackle in Tinkercad. The parts are all designed with interlocking parts to hold them together, and all have small tolerances built in to HOPEFULLY make them go together much more smoothly. This made a huge difference in my test prints, and hopefully it does for any of you as well. Included are many part variations to make it easier to print with the quality you want from it. As an example, there are multiple variations of the clock faces, allowing you to print either an all in piece, or to print the dials seperately, face up to get a cleaner look. The faces also have a variant that should allow you to install quartz clock movements for anyone who wants to make theirs actually work. (I will test this in the future) There are also options for things like the central tower, which can be printed in one piece, or in sections, to make scaling the print up easier. By default, the print comes out at 8 inches, or 20 centimeters tall, and was scaled so the largest piece could be printed on my photon with some wiggle room. TO BUILD You will need to print a set of parts that match. Some of the parts are optional, and I have named the parts to help with this. The Central Tower Section has the most options, for both Plain, and with the Embossed Demon, as well as complete or sectioned pieces to help the tower fit more compactly when scaled up. Be sure to check which parts you want for this. This goes the same with the actual Dials or Faces of the clock. There are options to allow you to print a preassembled piece, to print the hands seperately, or even to print the dials themselves seperately. Be sure check which parts you are printing. Happy Printing.