Hawkeye Firefly Micro Cam 2- CASE

thingiverse

This simple camera case is a big improvement over the stock silicone slip case. It offers much better protection for the entire camera, including the front lens and all its buttons, LEDs, micro SD card, and connectors. I printed these cases using 30D TPU without any support material and had no issues at all, just like I do with other FLEX parts. A suggested layer height is between 0.16-0.24mm, and an infill of more than 20% works well. To slide the camera into the case, you'll need to position it in front, but if there are any issues, you may need to trim a small part that protects the lens. However, this is only likely to be a problem if you're using very stiff material, which I don't encounter with 30D FLEX.