Hatching Wabbit

myminifactory

I'm launching my first project on MyMiniFactory today, entering the TinkerCAD Easter Challenge with this design as my entry point. This is also my inaugural TinkerCad Project. To ensure a smooth print of Mr. Wabbit, it's essential to avoid supports altogether; printing without supports will allow the hole to remain unfilled and the Egg to fit snugly around him. Although the Wabbit Egg doesn't require any support, feel free to use it if you prefer that method. When removing the eggshell quarters, gently rock them back and forth to loosen their grip. Mr. Wabbit can either spring out of his Egg or stay within by rotating him in the opposite direction from his normal position inside the egg.