HARRY POTTER Golden Snitch

cults3d

This golden snapper is composed of three pieces: the body/sphere, the right wing and the left wing in symmetry. Print parameters: Sphere: Materials: ABS (for acetone smoothing) Layer thickness: 0.12 mm Filling: 20%. Contour/perimeter shells: 3 (For good surface finish after smoothing with acetone) Generate a small area of support under the gold snapper for a good impression. Wings: Materials: PLA Nozzle diameter: max 0.4 mm (Change the "extrusion width" setting (max 0.4 mm) if the nibs do not print) Layer thickness: 0.2 mm Filling: 100 Post treatment: Sphere: Remove supports, deburr if necessary Place in oven to smooth outer surfaces Lightly sand if any unsmooth areas remain Paint the sphere of the golden snapper. I used gold spray paint. Wings: Deburr if necessary Lightly sand both sides Heat the front structure with a hair dryer to give it the desired curvature. Paint the wings Finally, assemble and glue the two wings to the sphere in the holes provided. Drill the holes to the correct diameter if necessary. This snitch is made up of three parts: the body / sphere, the right wing and the left wing in symmetry. Print settings : Sphere: Materials: ABS (for acetone smoothing) Layer thickness: 0.12mm Filling: 20 Contour / perimeter shells: 3 (For a good surface condition after smoothing with acetone) Generate a small area of support under the snitch for a good impression. Wings: Materials: PLA Nozzle diameter: max 0.4 mm (Modify the "extrusion width" parameter (max 0.4 mm) if the feather grips do not print) Layer thickness: 0.2 mm Filling: 100 Post-processing Sphere: Remove the supports, deburr if necessary Put in an oven to smooth the exterior surfaces Lightly sand if there are non-smooth areas Paint the golden snake sphere. I used gold spray paint. Wings: Deburr if necessary Lightly sand both sides Heat the front structure with the hair dryer to give it the desired curvature. Paint wings Finally, assemble and glue the two wings on the sphere in the holes provided for this purpose. Drill the holes to the correct diameter if necessary.